CNC Bender v11-20080424
CHANGES to CNC BENDER: Push Bending
Push-bending is achieved using roller dies rather than clamps and pressure dies. The tube is pushed by the carriage through the rollers. The bend arm is rotated to a position that will cause the tube to form into a large radius. The more angle on the bend arm, the smaller the resulting radius. This allows standard benders to create radius values much larger than is possible with draw bending alone.
The setup is performed in this menu:
Each profile row contains a profile setup for a given radius. An unlimited number of profile values can be entered. Read more about how the Push Bending Profile Table works. Using this method of calculation, it is possible to calculate different Push Bends by indicating the bend angle.
The low level option is a safety feature that disables all push-bending until the feature is enabled.