Benderlink for CNC Bender

Purchase a bender license of Benderlink for CNC Bender

Click on the image to download a CNC Bender ProControl Benderlink datasheet

Enable Automatic Setup and Correction
from MEASURING CENTERS and
CAD Programs Like SolidWorks

Teach the CNC Bender to the Correct Part Shape

Correction is like steering a car - the measuring center steers the bender to the correct part shape by transferring corrections through Benderlink

Faster Setup

Each bi-directional transmission with the bender takes only a few seconds and teachs the bender how make the part better than before.

Your setup time is dropped from hours to a few minutes.

Fitting the Gauge Like a Glove

If you're hard gauging, then the part will drop into the gauge faster every time.

And the process actually serves as a cross-check for your inspection process. If the measuring center and the gauge say you're in tolerance, then you have double the assurance that the part is correct.

(This is a sample bend check fixture from www.clarkfixtures.com)

Read Details in the Knowledgebase

Read details by clicking on the knowledgebase lightbulb

Tutorial 1 - Sending new data from a VECTOR Tube Data Center

View the video on how to let a Vector Tube Data Center establish new data at CNC Bender ProControl v12

Tutorial 2 - Sending Correction Data from a VECTOR Tube Data Center

How to allow a Vector Tube Data Center to Correct the data in a CNC Bender ProControl v12 bender.

ROMER The ROMER uses DOCS or SUPRAVISION software to measure tube shapes.
SHEFFIELD The Sheffield uses G-Tube software to measure tube shapes.
FARO Arm The FARO arm uses CAM2 to measure tubing. Use Benderlink for FARO to communicate with Benderlink for Eaton Leonard.
EL Vector The Vector Tube Data Center uses Laservision to measure tube shapes. The communications protocol is legacy EL current loop.
MM5000 The Multi Measure 5000 uses SUPRAVISION software to measure tube shapes.